Introduzione

This guide will provide instructions on how to replace the LCD screen for Kodak PixPro AZ251. Replacing the LCD screen may be necessary if the screen is cracked or becomes dislodged.

  1. Slide switch to open lock position. Slide switch to open lock position.
    • Slide switch to open lock position.

  2. Press down on the battery cover and slide outwards to open. Press down on the battery cover and slide outwards to open.
    • Press down on the battery cover and slide outwards to open.

  3. Remove the batteries.
    • Remove the batteries.

  4. Remove a total of four 5mm JIS #000 screws from around the camera: Two screws from the right side. Two screws from the left side.
    • Remove a total of four 5mm JIS #000 screws from around the camera:

    • Two screws from the right side.

    • Two screws from the left side.

  5. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  6. Remove the single 5mm Phillips #00 screw from the bottom.
    • Remove the single 5mm Phillips #00 screw from the bottom.

  7. Open the flash module. Remove the two 6mm JIS #00 screws found inside of the flash housing.
    • Open the flash module.

    • Remove the two 6mm JIS #00 screws found inside of the flash housing.

  8. Use a plastic opening tool to pry apart both halves of the camera. Remove the back panel. Remove the back panel.
    • Use a plastic opening tool to pry apart both halves of the camera.

    • Remove the back panel.

  9. Remove these three JIS #000 screws from the control board: 5mm screw.
    • Remove these three JIS #000 screws from the control board:

    • 5mm screw.

    • 4mm screw.

    • 2mm screw.

  10. Pull the small metal switch plate to the side.
    • Pull the small metal switch plate to the side.

  11. Pry the LCD screen out of the metal housing plate with a plastic opening tool. Pry the LCD screen out of the metal housing plate with a plastic opening tool.
    • Pry the LCD screen out of the metal housing plate with a plastic opening tool.

  12. Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket. Pull the orange cable out of the socket.
    • Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.

    • Pull the orange cable out of the socket.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team S1-G1, Cagle Spring 2018 Membro di USF Tampa, Team S1-G1, Cagle Spring 2018

USFT-CAGLE-S18S1G1

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 21

Tutti i Tempi: 206