Introduzione

Removing the back cover of your Kodak PixPro AZ251 gives you access to the camera's LCD screen and motherboard. This guide will instruct you on how to remove the back cover of your Kodak PixPro AZ251.

Slide switch to open lock position.
  • Slide switch to open lock position.

Aggiungi Commento

Press down on the battery cover and slide outwards to open.
  • Press down on the battery cover and slide outwards to open.

Aggiungi Commento

  • Remove the batteries.

Aggiungi Commento

  • Remove a total of four 5mm JIS #000 screws from around the camera:

    • Two screws from the right side.

    • Two screws from the left side.

Aggiungi Commento

  • Remove the single 5mm Phillips #00 screw from the bottom.

Aggiungi Commento

  • Open the flash module.

  • Remove the two 6mm JIS #00 screws found inside of the flash housing.

Aggiungi Commento

  • Use a plastic opening tool to pry apart both halves of the camera.

  • Remove the back panel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Luiza Oliveira

Membro da: 22/02/2018

205 Reputazione

2 Guide realizzate

Team

USF Tampa, Team S1-G1, Cagle Spring 2018 Membro di USF Tampa, Team S1-G1, Cagle Spring 2018

USFT-CAGLE-S18S1G1

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 7

Tutti i Tempi: 61