Salta al contenuto principale

Introduzione

Replacing the camera buttons.

Parti

Nessuna parte specificata.

  1. Use your finger tip to slide battery cover door away from the center of the camera.
    • Use your finger tip to slide battery cover door away from the center of the camera.

    • The battery door should spring open.

    • If this does not happen, gently open the door lifting from the outer bottom side of the camera.

  2. Remove the old batteries.
    • Remove the old batteries.

  3. Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now

    Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now
  4. Remove 7 screws from the outer case with a Phillips #00. All screws are 4.45mm. There are 2 screws on the port side.
    • Remove 7 screws from the outer case with a Phillips #00.

    • All screws are 4.45mm.

    • There are 2 screws on the port side.

    • There are 2 screws on starboard side.

    • There are 3 screws on the bottom.

  5. Make sure the battery cap is "up". Pull the outer case off with your hands. Pull the outer case off with your hands.
    • Make sure the battery cap is "up".

    • Pull the outer case off with your hands.

  6. Remove the necessary broken buttons.
    • Remove the necessary broken buttons.

    • They come out easily so just use your fingers.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Taggart Ashby

Membro da: 15/04/2010

315 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 26-19, Regan Spring 2010 Membro di Cal Poly, Team 26-19, Regan Spring 2010

CPSU-REGAN-S10S26G19

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 2,589