Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take out the screw which holds on the silver band using a Phillips #2 screwdriver.
-
Remove the silver band.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four Phillips #2 screws located around the mixer where the band was removed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the top of the mixer to reveal the inner parts.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the selector switch.
-
Remove the two Phillips #2 screws holding the selector switch in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the cords attached the drive motor to the switch.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two Phillips #2 screws holding the motor in place, located near the fan at the back of the motor.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
3 Commenti
anyone know where I can get the hall effect sensor receiver that is on the motor shaft? Somehow it's missing?
I accidentally pluged my 110v mixer to 220v. Now, what are the possible parts that i need to change? How can i check if the motor is busted?