Introduzione

If your device is not turning on, it may be the result of a faulty power cord. This guide demonstrates how to replace it.

Parti

Nessuna parte richiesta.

  1. Using a Phillips #2 screwdriver, remove the 10mm screw on the back cover by rotating it counterclockwise.
    • Using a Phillips #2 screwdriver, remove the 10mm screw on the back cover by rotating it counterclockwise.

    • The back cover is now free. Remove it by pulling back and up on the cover.

    Aggiungi Commento

  2. Using a Phillips #2 screwdriver, remove the 5mm screws holding the trimband to the top housing by rotating them counterclockwise.
    • Using a Phillips #2 screwdriver, remove the 5mm screws holding the trimband to the top housing by rotating them counterclockwise.

    • Pull the trimband off the housing by grabbing each side and pulling it off the front.

    Aggiungi Commento

    • Using a Phillips #2 screwdriver, remove the 12mm screw holding the grounding wire in place by rotating it counterclockwise.

    • Using pliers or tweezers, remove the connectors attached to the white and black wires.

    Aggiungi Commento

    • Using a screwdriver, pull the cord string relief out of the mixer by putting it behind the cord and pulling away from the mixer until it is free.

    • Remove the cord from the mixer body.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Max Prohorov

Membro da: 24/01/2018

109 Reputazione

1 Guida realizzata

Team

Cal Poly, Team S2-G5, Livingston Winter 2018 Membro di Cal Poly, Team S2-G5, Livingston Winter 2018

CPSU-LIVINGSTON-W18S2G5

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 86