Kindle Fire HD 8.9" Midframe Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

Use this guide to replace the metal midframe on the interior of the Kindle Fire HD 8.9". Removing this metal casing is a prerequisite for replacing most of the Kindle Fire HD's internal components.

Cosa ti serve

Passo 1 Screen

Kindle Fire HD 8.9" Midframe Replacement, Screen: passo 1, immagine 1 di 3

Kindle Fire HD 8.9" Midframe Replacement, Screen: passo 1, immagine 2 di 3

Kindle Fire HD 8.9" Midframe Replacement, Screen: passo 1, immagine 3 di 3

Insert a large plastic opening tool next to the Kindle's headphone jack.
Make sure the notch on the plastic opening tool is facing the back of the Kindle.
Move the plastic opening tool evenly around the Kindle, separating the two halves.
Be careful not to completely separate the rear cover. There are two delicate flex cables that connect the display assembly to the motherboard.

Traduci

Passo 2

Set the Kindle down on the rear case.
Holding the display assembly near the camera, carefully open the display assembly up to about 90 degrees from the rear case.
These images show the Kindle laying flat. In order to prevent damage to the flex cables, keep the Kindle open at 90 degrees while disconnecting the display assembly.

Traduci

Passo 3

Kindle Fire HD 8.9" Midframe Replacement: passo 3, immagine 3 di 3

Lift the retaining flap on the ZIF connector of the upper flex cable.
Gently pull the cable out of its socket.
This flex cable is delicate. Be careful not to crease or bend it while working.

Traduci

Passo 4

Separate the display assembly from the rest of the device.
When reassembling the device, align the two halves of the case before connecting the flex cables.

Traduci

Passo 5 Inner Metal Casing

Kindle Fire HD 8.9" Midframe Replacement, Inner Metal Casing: passo 5, immagine 1 di 2

Kindle Fire HD 8.9" Midframe Replacement, Inner Metal Casing: passo 5, immagine 2 di 2

Remove the following sixteen screws from the metal midframe on the rear of the device:
One 3 mm Phillips screw from each corner
Four 3 mm Phillips screws surrounding the ports
Eight 3 mm Phillips screws from the body of the midframe