Salta al contenuto principale

KidzLane Walkie-Talkie Press-to-speak button Replacement

Cosa ti serve

  1. KidzLane Walkie-Talkie Press-to-speak button Replacement, Press-to-speak button: passo 1, immagine 1 di 1
    • Place the Walkie-Talkie on a flat surface-preferably a table or a desk.

    • Flip the device over to where you see four screws in each corner.

    • Make sure you take out the batteries before proceeding.

  2. KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 2, immagine 1 di 2 KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 2, immagine 2 di 2
    • Using your Phillips head screwdriver, unscrew all four 4mm screws from each corner.

  3. KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 3, immagine 1 di 1
    • Once you have unscrewed all four corners, open the device so it will be in two parts.

    • As you're opening the inside of the Walkie-Talkie, don't break off any wires within the device.

    • Taking the Phillips head screwdriver again, unscrew the three screws on the circuit board (green plate).

    • Separate these screws from the other four since they are different sizes.

  4. KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 4, immagine 1 di 2 KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 4, immagine 2 di 2
    • Take the circuit board out of the plastic casing.

    • Use the soldering device to iron the silver box (press-to-speak button), and then remove it from the circuit board.

Linea Traguardo

Altre 2 persone hanno completato questa guida.

Amin

Membro da: 02/13/16

642 Reputazione

5 Guide realizzate

Team

IUPUI, Team 1-1, Wilson Spring 2016 Membro di IUPUI, Team 1-1, Wilson Spring 2016

IUPUI-WILSON-S16S1G1

4 Membri

5 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 5

Tutti i Tempi: 898