Introduzione

This repair might be needed when the buttons in the face plate become broken or lost.

  1. Press the ejection  button on the lower left corner of the face plate.
    • Press the ejection button on the lower left corner of the face plate.

    Aggiungi Commento

  2. Remove the face plate by pulling upwards and in the direction of the ejection button.
    • Remove the face plate by pulling upwards and in the direction of the ejection button.

    Aggiungi Commento

    • Remove the three 7.5mm Phillips #1 screws.

    Aggiungi Commento

    • Separate the two halves of the housing by prying along the length of the device with a plastic opening tool.

    Aggiungi Commento

    • Remove the motherboard from the housing.

    Aggiungi Commento

    • Remove the 5.5 mm Phillips #00 screw.

    • Remove the clear plastic piece by carefully prying it away from the plastic housing.

    Aggiungi Commento

    • Remove the gray rubber piece by pulling it upwards and away from the plastic housing.

    • Use the pointed end of a spudger to pry out the buttons.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Andrew Waldon

Membro da: 05/07/2018

265 Reputazione

3 Guide realizzate

Team

IUPUI, Team S2-G4, Harley Summer 2018 Membro di IUPUI, Team S2-G4, Harley Summer 2018

IUPUI-HARLEY-SU18S2G4

3 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 47