Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Use this guide to replace a faulty electronic control on your Kenmore 110 Washing Machine.

  1. Unplug the washing machine!
    • Unplug the washing machine!

    • Using a 5/16" socket wrench or an adjustable wrench, remove the three screws from the top rear of the washer.

    • Lifting from the rear, remove the top panel.

    • The top panel will still be connected by wires and hoses. It will help if you have a flat raised surface to set the top panel on.

  2. Using a 5/16" socket wrench or a hand wrench, remove the two screws from the component cover. From the bottom, pull out and remove the component cover. From the bottom, pull out and remove the component cover.
    • Using a 5/16" socket wrench or a hand wrench, remove the two screws from the component cover.

    • From the bottom, pull out and remove the component cover.

  3. Carefully remove the three wire harnesses. With a phillips head screwdriver, remove the three mounting screws.
    • Carefully remove the three wire harnesses.

    • With a phillips head screwdriver, remove the three mounting screws.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 9 persone hanno completato questa guida.

Robert Trout

Membro da: 26/09/2012

991 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 15-43, Forte Fall 2012 Membro di Cal Poly, Team 15-43, Forte Fall 2012

CPSU-FORTE-F12S15G43

5 Membri

10 Guide realizzate

the machine is not completing the wash cycle. stop in the rinse and spin cycle.

is there a fix for this?

R Snagg - Replica

I am having the same problem. Did you ever find a fix?

Paul Bennett -

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 4

Ultimi 7 Giorni: 21

Ultimi 30 Giorni: 77

Tutti i Tempi: 21,955