Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the standard metal spudger, begin by prying at the bottom of the plain rubber end cap (the end without the USB or auxiliary input).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Continue prying around the end panel, prying at different points until the entire panel is out of its seating.
-
Carefully remove the end panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide out the rubber foot located on the bottom of the case.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a T6 bit, remove the flat topped 5mm screw located on the bottom of the casing, underneath the rubber foot.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push against the side without end cap to slide the internal components out of the case.
-
While holding the metal outset casing with one hand, press on the black inner plastic casing with your thumb.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove all connecting ribbons from the motherboard.
-
One ZIF or "zero insertion force" ribbon connecting at the side.
-
One standard ribbon connector in the middle (Note: this ZIF ribbon is lightly glued to the surface).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew all four 5mm T6 screws holding the motherboard to the plastic case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Desolder the grounding plug from the motherboard.
-
Make sure your soldering iron is tinned and carefully touch the tip of your iron to the grounding lug. Allow the the solder to liquify. While liquified, lift the motherboard off the grounding lug.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully lift the motherboard out of the plastic housing.
-
Annulla: non ho completato questa guida.
Altre 6 persone hanno completato questa guida.