Introduzione

The motherboard is the most important part of the Jabra CRUISER2. It controls the device. This guide will tell you step-by-step how to remove the motherboard so you can replace it with a functioning one.

Use the iOpener tool to unglue the adhesive of the device. The link to the iOpener instructions are listed below.
  • Use the iOpener tool to unglue the adhesive of the device. The link to the iOpener instructions are listed below.

  • iOpener Instructions

Aggiungi Commento

Place the flat head of the bigger plastic opening tool in between the front plate and back plate.
  • Place the flat head of the bigger plastic opening tool in between the front plate and back plate.

  • Pull the tool toward the back of the device to pry it open.

  • Repeat this process over all edges of the device.

Aggiungi Commento

  • Open up the device by pulling the front plate straight up from the back plate.

Aggiungi Commento

  • Carefully detach the wire running from the speaker to the motherboard by unplugging it from the white socket.

Aggiungi Commento

  • Using the PH000, unscrew the three 4.55 mm screws in the motherboard.

  • The names of the screwdriver heads are listed on the sides of each head.

Aggiungi Commento

  • Remove the motherboard from the device by lifting it up from the back plate.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Spartacus

Membro da: 17/10/2014

564 Reputazione

5 Guide realizzate

Team

Baylor, Team 8-13, Williams Fall 2014 Membro di Baylor, Team 8-13, Williams Fall 2014

BU-WILLIAMS-F14S8G13

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 9

Tutti i Tempi: 562