Salta al contenuto principale

JBL L26 Speaker Replacement

Cosa ti serve

  1. JBL L26 Speaker Replacement, Speaker: passo 1, immagine 1 di 1
    • Remove the four 6.4 mm Phillips #2 screws from the front of the speaker.

  2. JBL L26 Speaker Replacement: passo 2, immagine 1 di 1
    • Pull the speaker out of the frame and lay it onto the side.

  3. JBL L26 Speaker Replacement: passo 3, immagine 1 di 1
    • Unlatch the green wire by pulling on the terminal connector and not the wire.

  4. JBL L26 Speaker Replacement: passo 4, immagine 1 di 2 JBL L26 Speaker Replacement: passo 4, immagine 2 di 2
    • Use a small prying tool to pry the terminal connector off of the tap.

    • After you unlatched both edges, pull the black wire out.

  5. JBL L26 Speaker Replacement: passo 5, immagine 1 di 1
    • Get your replacement speaker and connect the green wire by pushing the terminal connector onto the tap.

  6. JBL L26 Speaker Replacement: passo 6, immagine 1 di 2 JBL L26 Speaker Replacement: passo 6, immagine 2 di 2
    • Connect the black wire by attaching the terminal connector onto the tap.

    • Use a clamping tool to clip the edges toward the tap.

    • Be careful not to clamp too hard so you don't damage the tap.

  7. JBL L26 Speaker Replacement: passo 7, immagine 1 di 1
    • Place the new speaker onto the frame and screw the four 6.4 mm Phillips #2 screws back in.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 11

Tutti i Tempi: 1,080