Introduzione

The JBL Charge 3 has two front speaker that can be replaced individually or together. If your speakers are blown out replace them with this guide.

  1. Turn your speaker upside down and insert the plastic opening tool vertically into the slit in the front cover.
    • Turn your speaker upside down and insert the plastic opening tool vertically into the slit in the front cover.

    • Slowly pull the plastic opening tool outward to remove the four clips holding the covering in place.

    • Repeat this process for all four edges of the front cover.

    Aggiungi Commento

  2. Pull apart your cover gently from both sides and remove it from the speaker housing.
    • Pull apart your cover gently from both sides and remove it from the speaker housing.

    • The inside of the front cover has holes that must match with their corresponding pins on the speaker housing for proper reassembly.

    • Any further disassembly of your speaker will require removing waterproof seals and gaskets. Your device may no longer be waterproof after these have been altered.

    Aggiungi Commento

    • Remove the eight 10mm Phillips #1 screws from around the two front speakers.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Pull gently on one of the speakers so it is outside of the housing. Be careful as it is still attached with the wires to the motherboard.

    Aggiungi Commento

    • Press the small metal tab on the speaker connector with a Phillips #000 screwdriver and gently pull the connector apart.

    Aggiungi Commento

    • Repeat the previous step for the second connector.

    Aggiungi Commento

    • Grab the bundled cable connector that joins the speakers to the motherboard with tweezers. Gently pull the connector free.

    Aggiungi Commento

    • Now that the second speaker is disconnected from the motherboard, pull the speaker and wires out of the housing.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aidan Hays

Membro da: 08/10/2018

272 Reputazione

2 Guide realizzate

Team

Cal Poly, Team S13-G1, White Fall 2018 Membro di Cal Poly, Team S13-G1, White Fall 2018

CPSU-WHITE-F18S13G1

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 13

Ultimi 7 Giorni: 117

Ultimi 30 Giorni: 125

Tutti i Tempi: 143