Introduzione

Does your device not turn on or does the power run out quickly? It is probably the result of a dysfunctional battery. This guide will show you how to remove your battery for a replacement. Be aware that this guide has some steps that can possibly damage the device.

Parti

Nessuna parte richiesta.

Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.
  • Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.

Aggiungi Commento

Detach the back cover by carefully pulling up and out on the back plastic casing.
  • Detach the back cover by carefully pulling up and out on the back plastic casing.

  • Do not pull apart the red wire connecting the battery to the device.

Aggiungi Commento

  • Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.

  • Be careful to not tear the wires while opening the case.

Aggiungi Commento

  • Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.

  • Do not disconnect wires from plastic connector.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 12-36, Amido Spring 2013 Membro di Cal Poly, Team 12-36, Amido Spring 2013

CPSU-AMIDO-S13S12G36

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 820