Introduzione

The Insignia 2-in-1 Handheld vacuum button may get jammed or the electrical components can stop working. In either case, this guide can show you how to fix or replace the power button.

Parti

Nessuna parte richiesta.

  1. Push down the black button to release the dust cup.
    • Push down the black button to release the dust cup.

    • Pull the dust cup up and away from handheld portion to remove.

    Aggiungi Commento

  2. Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.
    • Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.

    • Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

    Aggiungi Commento

    • Pull apart the red and black wires.

    • Do so for all of the wires. (Red x1, Black x2)

    Aggiungi Commento

    • Remove the tape holding the battery to the black housing.

    • Slide the entire battery bundle out.

    Aggiungi Commento

    • Remove motor and impeller housing to gain access to power button.

    Aggiungi Commento

    • Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.

    Aggiungi Commento

    • Remove the two 10mm Philips #2 screws holding the brown printed circuit board to the vacuum.

    • Remove brown printed circuit board.

    • Pull up on clear plastic power button assembly to remove.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

Membro da: 15/02/2018

428 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S16-G3, Boczar Spring 2018 Membro di USF Tampa, Team S16-G3, Boczar Spring 2018

USFT-BOCZAR-S18S16G3

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 68