Aggiusta la tua roba Comunità Store

Insignia NS-HTMC01-B Power Cord Replacement

Introduzione

This guide will take you through the process of replacing the power cord of the Insignia NS-HTMC01-B.

Cosa ti serve

  1. Insignia NS-HTMC01-B Power Cord Replacement, Front Case: passo 1, immagine 1 di 3 Insignia NS-HTMC01-B Power Cord Replacement, Front Case: passo 1, immagine 2 di 3 Insignia NS-HTMC01-B Power Cord Replacement, Front Case: passo 1, immagine 3 di 3

    • Flip the device over so the back panel faces up.

    • Unscrew the four screws counter-clockwise from the back panel using a 4mm Phillips screwdriver.

    • You may want to use a flashlight during this step, as the screws are hard to see.

    • Make sure to firmly connect your screwdriver with the head of the screw. A loose connection can strip the screw head, making the screws nearly impossible to remove.

    Modifica

  2. Insignia NS-HTMC01-B Power Cord Replacement: passo 2, immagine 1 di 1

    • Take the screws out and set them aside.

    • Be sure to set them somewhere flat, so they don't roll away.

    • Gently pull the front panel and back panel apart to open the device.

    Modifica

  4. Insignia NS-HTMC01-B Power Cord Replacement, Power Cord: passo 3, immagine 1 di 1

    • Use a Phillips #2 screwdriver to remove the two 1.7mm screws from the white triangular piece covering the power cord.

    Modifica

  5. Insignia NS-HTMC01-B Power Cord Replacement: passo 4, immagine 1 di 1

    • Disconnect all of the blue wires. There should be 3 separate blue-wire connections.

    Modifica

  6. Insignia NS-HTMC01-B Power Cord Replacement: passo 5, immagine 1 di 1

    • Disconnect the second black wire from the rectangular piece above the Tip-Over Safety Switch.

    • Remove power cord.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 5

Tutti i Tempi: 188