Introduzione

This guide will show the required steps to replace the ice tray on the Insignia Ice Maker.

  1. Remove the 6 screws holding the rear casing on.
    • Remove the 6 screws holding the rear casing on.

    • Remove the rear casing

    Aggiungi Commento

  2. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.
    • Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.

    Aggiungi Commento

    • Remove the 4 screws holding the Ice Tray from the top.

    Aggiungi Commento

    • Lift the Water Pump out of the way

    Aggiungi Commento

    • Remove the final 2 screws.

    Aggiungi Commento

    • Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.

    • Disconnect the water tray cord.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Evan Taylor

Membro da: 18/01/2018

544 Reputazione

5 Guide realizzate

Team

Cal Poly, Team S21-G3, Banghart Winter 2018 Membro di Cal Poly, Team S21-G3, Banghart Winter 2018

CPSU-BANGHART-W18S21G3

2 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 10

Tutti i Tempi: 100