Aggiusta la tua roba Comunità Store

India Mark II Head Section Replacement

Guida Archiviata
Questa guida è mantenuta solo per scopi storici. Usa la versione aggiornata della guida per eseguire la riparazione.

Introduzione

Remove and or replace the head section of the India Mark II water hand pump.

Cosa ti serve

  1. India Mark II Head Section Replacement, Cover Plate: passo 1, immagine 1 di 1

    • Use a wrench to remove the bolt on the top of the cover plate.

    • When replacing the cover plate, this bolt only needs to be hand tight.

    Modifica

  2. India Mark II Head Section Replacement: passo 2, immagine 1 di 1

    • Remove the top cover by pulling it straight off the pump.

    • Store the top cover in a sanitary place, preferably above ground, to prevent contamination.

    Modifica

  4. India Mark II Head Section Replacement, Head Section: passo 3, immagine 1 di 3 India Mark II Head Section Replacement, Head Section: passo 3, immagine 2 di 3 India Mark II Head Section Replacement, Head Section: passo 3, immagine 3 di 3

    • Pull the pump handle all the way down and hold it in this position, exposing the pump rod.

    • Place the spacer around the pump rod and under the chain attachment point.

    • Make sure the spacer is beveled side down, and flat side up.

    • Lift the pump lever until there is no tension in the chain and hold it in this position.

    Modifica

  5. India Mark II Head Section Replacement: passo 4, immagine 1 di 2 India Mark II Head Section Replacement: passo 4, immagine 2 di 2

    • Remove the bolt connecting the chain to the pump handle.

    • Remove the chain from the handle.

    Modifica

  6. India Mark II Head Section Replacement: passo 5, immagine 1 di 3 India Mark II Head Section Replacement: passo 5, immagine 2 di 3 India Mark II Head Section Replacement: passo 5, immagine 3 di 3

    • There are 4 bolts securing the head section to the water tank, located at the corners of head section base.

    • Continue supporting the pump handle so the pump head doesn't fall off when all the bolts are removed.

    • Remove the 4 bolts on the base of the water tank.

    Modifica

  7. India Mark II Head Section Replacement: passo 6, immagine 1 di 1

    • Lift the pump head off of the water tank and place in a sanitary place, preferably above ground, to prevent contamination.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 4 altri collaboratori

Phillip Takahashi

Membro da: 08/22/11

86.704 Reputazione

87 Guide realizzate

Distintivi: 43

+40 altri distintivi

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 662