Introduzione
Se possiedi l'xBox One Play & Charge Kit e non si ricarica via USB, prova questa soluzione facile, economica e super veloce. Non faccio promesse, ma ogni volta che ho provato questa soluzione, sono stato in grado di aggiustarlo. Quindi prova anche tu e vedi se funziona. In caso contrario avrai solo sprecato 2-5 minuti.
Per prima cosa assicurati che il controller funzioni con il cavo USB. Scollega la batteria e collega il cavo USB. Se il controller si accende, CONGRATULAZIONI!! Questa guida può esserti d'aiuto.
Procurati un po' di cartone o del nastro isolante in spugna a bassa densità (2,23$ per 5 metri da Home Depot) Per questa riparazione utilizzerò del nastro isolante in spugna a bassa densità.
Ritaglia un pezzetto piccolo. Intendo piccolo. La dimensione del tuo mignolo. Metti il nastro al centro del controller nell'alloggio della batteria. Poi inserisci la batteria. Premi GENTILMENTE. Tenendo la batteria in posizione, collega il cavo USB. Aspetta, (ci vuole un secondo circa) e la luce arancione sul cavo USB dovrebbe accendersi. In tal caso, riposiziona il coperchio della batteria mentre il cavo è collegato. In questo modo si può vedere se il collegamento si interrompe. In tal caso usa sempre lo stesso pezzo di nastro adesivo, ma taglialo solo un po' più piccolo. FUNZIONERÀ.
Nota- Il coperchio sarà più difficile da rimettere a posto- Attenzione a non rompere le alette. Non preoccuparti comunque, sono più robuste di quanto sembra.
Inoltre- ti suggerisco di collegare il controller ad un PC e non all'xBox. Non sono sicuro che la Xbox sia in grado di passare da un controller cablato a uno wireless per diverse volte di seguito.
Cosa ti serve
-
-
L'Xbox One - Play and Charge Kit non si ricarica quando è collegato all'USB.
-
-
-
-
Prendi un pezzetto di nastro in schiuma a bassa densità e posizionalo al centro del controller, con il lato adesivo che poggia sul controller.
-
Reinserisci la batteria.
-
Ricollega l'USB e premi GENTILMENTE la batteria nel controller mentre l'USB è collegato. Questo ti permetterà di vedere se la soluzione ha funzionato. NOTA- ci vuole un secondo circa perché la luce sul cavo USB si accenda dopo l'accensione del controller.
-
-
-
Se tutto è andato bene, è possibile riposizionare il coperchio della batteria. Fai attenzione però, perché sarà molto più difficile rimontarlo. Non preoccuparti, quei piccoli clip sono molto più resistenti di quanto pensi. Prenditi il tuo tempo e fai attenzione. Se non si adatta - non forzarlo, prova invece a tagliare via parte del nastro.
-
Ecco fatto. Ora puoi ricaricare il tuo controller normalmente. Almeno non dovremo dare più soldi alla MS per farlo riparare.
Ecco fatto. Ora puoi ricaricare il tuo controller normalmente. Almeno non dovremo dare più soldi alla MS per farlo riparare.
Annulla: non ho completato questa guida.
Altre 26 persone hanno completato questa guida.
Un ringraziamento speciale a questi traduttori:
100%
Simone ci sta aiutando ad aggiustare il mondo! Vuoi partecipare?
Inizia a tradurre ›
35 Commenti
Thanks mate, squeezed on the battery (in towards the controller) as I inserted the cable and the light appeared on the cable. Before I tried just plugging it in to no help in result of the led indicator on the cable. But this solved it, thought I had a faulty battery/controller for a sec. Saved me some bucks there, much appreciated
Glad it worked for you. Thanks for leaving a comment. Please note though I had this issue but as it turns out it was my controller. I did end up buying a new one. But in a pinch or at 2am this will help and keep you from tossing the %#*@ thing out the window.
Doesn’t work. Tried a know working battery from my other controller (which works in that controller), to no avail. Tried another battery from another controller that it works, nothing. The problem is the controller, not my battery (which is new).
Worked for me thanks man!
U mnie niby ładuje, ale następnego dnia pokazuje, że jest rozładowany…
This did work! At first I thought I had damaged the cable since I used it to charge a phone. I used a tiny piece of packing foam and at first it didn't seem to work. Then it occured to me, I have a second controller! So I pulled out the battery and used the cable and it worked. So I confirmed the battery and the cable were good, I repeated the method on the first controller and it worked. Thanks for the tip!
**Some background the controllers are three months old and the Play and Charge kit is brand new.
This solution worked for me. Bought MS Xbox one play and charge kit in Feb 2020, just got around to trying it and found it wouldn’t charge the battery pack, though the cable would power the controller . I had spare weatherstrip draught proofing foam and used a small piece of that.
Thank you.
Works fine. Brandnew Xbox One controller with charge kit wouldn’t charge. Piece of foam, voila working. Had to put the piece of foam a bit more towards the LB side.
Works, just used a small piece of cardboard. - There’s obviously a few tolerance problems in the tooling.
I added the cardboard as advised, but my controller still won’t charge. The white light on the usb comes on and the controller is working fine, however the amber light won’t come on. It is showing that my battery is fully charged, but when i disconnect the cable, pops up with controller battery low and then my controller switches off.
Any other Ideas on how to tackle this? my one x controller is only 2 years old and it has been working fine. Play and charge kit is from 2015 but that shouldn’t really matter, or do you think the battery might have gone? Thanks in advance
Update to my previous comment: OK so i tried again and this time the orange light on the USB lights up, but only for about 30 seconds and then turns back to the white colour indicating that the battery is fully charged (obviously that isn’t the case). Do you think possibly faulty battery? Or should i add a bit more cardboard / foam ?
I have a similar problem. The led on the cable lights up white when I know the battery needs charging and the xbox battery indicator on screen shows it to not be charging. I don’t now what the answer is!
Works fine for me (with cartboard). Try diffrent sizes of this cartboard Square. Probably it is diffrent for each controller. Thank you very much bbhsascha <3
Worked a treat, thanks very much!
Yes, it works. I couldn’t believe it has this kind of issue until I tried.
It worked for me. Thank you! Just wondering for how long will it last?
I’m glad it worked for you. For me it worked for about a week before I bought a new controller and battery pack. I’m theory it will work until the foam can no longer expand. You should be able to just change the foam.
Didn’t have any Low-Density Foam Weatherstrip Tape, but i managed fold some thick paper from a rollie paper packet instead and it worked, kinda blown away tbh, thanks!
i just put a bit of pressure while i was inserting the battery while the usb was plugged in and it worked- first i cleaned the connectors on the battery lol. thanks so much
This fix worked for me. Brand new controller with brand new play & charge kit. pretty disappointing Quality Control from Microsoft…
I think the alignment of the contacts in the battery pack to the controllers are not optimal. The fit is not right. This should be fixed by the designers. Very bad design indeed!
I got the new battery that does not includes the light in the cable in the old battery the controller shake when i plugged it in but now it doesn’t and does not charge
Thanks! This worked and just saved me from buying a new Play n Charge kit :D
Perfect, sometimes it is so easy, thanks for this good explanation ✊
This worked for me and I didn’t even use the foam. I just lightly pressed the battery in place.
Having said that, I am not getting a light on my cable but I can see it’s charging from my dashboard.
Thanks!
Super wierd... it worked.. Thanks. then I suppose that something inside is not working as it should, maybe I will open up and check later. thanks!
THANK YOU VERY MUCH! I used a piece of paper and put it the same way you did and it worked! Thanks again for this fix 👌💪💪
Incredible! Simple fix to a really annoying broken design. Did work at first try! 🤩
Worked! Orange light finally came on…. white keeps coming on premature tho…battery is toast im guessing
yellow_scientist - Replica
It actually worked. Surprised but thanks for the fix
Deepankur Kalia - Replica