Salta al contenuto principale

Introduzione

This guide will demonstrate the removal and replacement procedures for an IBM ThinkPad T42 Modem Daughter Board.

Parti

Nessuna parte specificata.

  1. Unscrew the 20 Phillips screws on the underside of the T42.
    • Unscrew the 20 Phillips screws on the underside of the T42.

    • For ease of reassembly, keep your screws organized.

  2. Unscrew the 2 Phillips screws on both sides of the T42's rear.
    • Unscrew the 2 Phillips screws on both sides of the T42's rear.

  3. Flip the laptop over and open the screen.
    • Flip the laptop over and open the screen.

    • The bezel and keyboard will be loose, be careful.

  4. Carefully maneuver the palm rest away from the keyboard, as both the keyboard and palm rest/trackpad will come off together. Remember, both the keyboard and trackpad have connectors to the motherboard. Disconnect these before completely removing either component.
    • Carefully maneuver the palm rest away from the keyboard, as both the keyboard and palm rest/trackpad will come off together.

    • Remember, both the keyboard and trackpad have connectors to the motherboard. Disconnect these before completely removing either component.

  5. Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

    Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now
  6. Starting from the bottom right, carefully remove off the bezel. Use a spudger or flat head screwdriver if needed. Starting from the bottom right, carefully remove off the bezel. Use a spudger or flat head screwdriver if needed.
    • Starting from the bottom right, carefully remove off the bezel. Use a spudger or flat head screwdriver if needed.

  7. The metal bracket will now be free to move, grasp it and remove it from the device. The metal bracket will now be free to move, grasp it and remove it from the device.
    • The metal bracket will now be free to move, grasp it and remove it from the device.

  8. Remove the small rubber piece that is covering the T42's microphone,
    • Remove the small rubber piece that is covering the T42's microphone,

  9. Next, unscrew the 3 Phillips screws in red.
    • Next, unscrew the 3 Phillips screws in red.

  10. The cables are routed through different components for organization, carefully disconnect them, unwrap them and pull the card free.
    • The cables are routed through different components for organization, carefully disconnect them, unwrap them and pull the card free.

  11. Lastly, remove the bracket sitting beneath it.
    • Lastly, remove the bracket sitting beneath it.

    • The end!

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 29-76, Johann Spring 2010 Membro di Cal Poly, Team 29-76, Johann Spring 2010

CPSU-JOHANN-S10S29G76

4 Membri

30 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 4,559