Salta al contenuto principale

Introduzione

How to remove the keyboard for repair or replacement on the IBM ThinkPad 560z.

  1. Remove the 7 mm Phillips #0 screws.
    • Remove the 7 mm Phillips #0 screws.

    • Remove the 10 mm Phillips #0 screws.

    • Remove the 14 mm Phillips #0 screw.

  2. Open the flap on the left hand side. Open the flap on the left hand side.
    • Open the flap on the left hand side.

  3. Insert the plastic opening tools between the right and left sides of the latch. Pry the right side  of the latch, and then pry the left side to detach the laptop's cover.
    • Insert the plastic opening tools between the right and left sides of the latch.

    • Pry the right side of the latch, and then pry the left side to detach the laptop's cover.

  4. Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora

    Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora
  5. Open the flap on the right side. Open the flap on the right side.
    • Open the flap on the right side.

  6. Insert the plastic opening tools towards the right side of the latch.
    • Insert the plastic opening tools towards the right side of the latch.

    • Gently pry the right side out to release the top cover.

  7. Lift the keyboard slowly. A cable connects the keyboard to the motherboard. If you are not careful, you will damage the cable.
    • Lift the keyboard slowly.

    • A cable connects the keyboard to the motherboard. If you are not careful, you will damage the cable.

  8. Use your fingers or a spudger to detach the connector.
    • Use your fingers or a spudger to detach the connector.

  9. Carefully lift and remove the keyboard. Carefully lift and remove the keyboard.
    • Carefully lift and remove the keyboard.

  10. Remove the five Phillips screws from the underside of the keyboard, then gently lift it up. Remove the five Phillips screws from the underside of the keyboard, then gently lift it up.
    • Remove the five Phillips screws from the underside of the keyboard, then gently lift it up.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Derek Driscoll

Membro da: 15/04/2010

119 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 26-27, Regan Spring 2010 Membro di Cal Poly, Team 26-27, Regan Spring 2010

CPSU-REGAN-S10S26G27

3 Membri

18 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 2,053