Introduzione

If you are having issues hearing other people on the TC-580 or the sound is distorted you will want to consider replacing the speaker. This will require some knowledge of soldering which could damage the circuit board of the radio, use other repair options unless you are confident in your soldering ability.

Remove the two 10mm Phillips #0 from the belt clip.
  • Remove the two 10mm Phillips #0 from the belt clip.

Aggiungi Commento

Push in the release button and pull up on the battery to remove.
  • Push in the release button and pull up on the battery to remove.

Aggiungi Commento

  • Twist antenna counter-clockwise and set damaged antenna aside.

Aggiungi Commento

  • Remove the volume knob by firmly lifting up on both sides of it.

Aggiungi Commento

  • Remove the orange o-ring around volume knob using tweezers.

Aggiungi Commento

  • Remove grey nut from base of volume knob by turning it counterclockwise with a set of tweezers.

Aggiungi Commento

  • Remove the brass washer from the base of the antenna slot by turning it counterclockwise with a set of tweezers.

Aggiungi Commento

  • Remove the two 15mm T8 Torx screws from the base of the battery cavity.

Aggiungi Commento

  • Using a plastic opening tool, pry in between the plastic case and metal circuit board to remove the board.

Aggiungi Commento

  • Peel off the keypad by hand.

Aggiungi Commento

  • Remove eleven 4mm Phillips #00 screws.

Aggiungi Commento

  • Apply a soldering iron to the solder joints to remove the two wires connecting the speaker to the circuit board.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Mohammed Chehab

Membro da: 14/02/2018

85 Reputazione

1 Guida realizzata

Team

USF Tampa, Team S3-G4, Nance Spring 2018 Membro di USF Tampa, Team S3-G4, Nance Spring 2018

USFT-NANCE-S18S3G4

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 56