Salta al contenuto principale

Huawei P9 Lite Motherboard Shield Removal

Cosa ti serve

  1. Huawei P9 Lite Motherboard Shield Removal, Back Cover: passo 1, immagine 1 di 2 Huawei P9 Lite Motherboard Shield Removal, Back Cover: passo 1, immagine 2 di 2
    • Use an opening pick to unclip the rear cover, starting from the bottom corner.

    • Work your way around counterclockwise and carefully pry the plastic tabs open one by one.

  2. Huawei P9 Lite Motherboard Shield Removal: passo 2, immagine 1 di 1
    • There is adhesive underneath the back cover that holds it to the battery and the metal plate at the top.

    • Be careful with the flex cable at the right hand side.

    • Twist the opening pick to lever the back cover away and loosen it from the adhesive.

  3. Huawei P9 Lite Motherboard Shield Removal: passo 3, immagine 1 di 1
    • When the back cover is freed from the adhesive you can pop it off by hand completely.

  4. Huawei P9 Lite Motherboard Shield Removal, Motherboard Shield: passo 4, immagine 1 di 1
    • Remove the nine Phillips #00 screws that secure the metal shield plate.

    • Some screws may be covered with tamper proof stickers. Remove them to ensure a proper seating for your driver.

  5. Huawei P9 Lite Motherboard Shield Removal: passo 5, immagine 1 di 2 Huawei P9 Lite Motherboard Shield Removal: passo 5, immagine 2 di 2
    • Do not remove the shield plate yet, it is attached by a connector and an adhered cable.

    • Use a spudger to disconnect the fingerprint sensor from the motherboard.

    • Peel the NFC antenna cable off of the metal plate.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Tobias Isakeit

Membro da: 03/31/14

117.588 Reputazione

188 Guide realizzate

Team

Master Techs Membro di Master Techs

Community

322 Membri

2.528 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 8

Tutti i Tempi: 5,954