Huawei P9 Back Cover

Passo 1 Back Cover




• First switch off your phone and remove the SIM card tray.
• Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port.
• If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.
Traduci
2 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 2



• Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
• Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
• In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.
• Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.
Traduci
19 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 3 Fingerprint sensor
• Disconnect the fingerprint sensor using a spudger.
Traduci
Aggiungi un commento
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento

Autore

con 6 altri collaboratori

Tobias Isakeit

Membro da: 03/31/14

117.296 Reputazione

188 Guide realizzate

Distintivi: 46

• 
• 
• 

+43 altri distintivi

Team

Master Techs Membro di Master Techs

Community

322 Membri

2.521 Guide realizzate

Incorpora questa guida

Scegli una dimensione e copia il codice qui sotto per incorporare questa guida come un piccolo widget sul tuo sito/forum.

Anteprima