Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Use this guide to replace the back cover of your Huawei P10 Lite.

  1. Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive. Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in. If the adhesive is hard to cut, use an iOpener to loosen it.
    • Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

    • Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in.

    • If the adhesive is hard to cut, use an iOpener to loosen it.

  2. After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone. Flip the rear cover over to the right side of the phone. Flip the rear cover over to the right side of the phone.
    • After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

    • Flip the rear cover over to the right side of the phone.

  3. Use a pair of tweezers to remove the sticker. Remove the two Phillips #00 screws.
    • Use a pair of tweezers to remove the sticker.

    • Remove the two Phillips #00 screws.

    • Remove the four 2.5 mm Phillips #00 screws.

  4. Use tweezers to remove the mainboard shield. Use the flat end of a spudger to disconnect the finger print sensor flex cable.
    • Use tweezers to remove the mainboard shield.

    • Use the flat end of a spudger to disconnect the finger print sensor flex cable.

    • When reassembling apply new adhesive where it is necessary.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 14 persone hanno completato questa guida.

Dominik Schnabelrauch

Membro da: 23/11/2016

73.510 Reputazione

323 Guide realizzate

Team

iFixit Membro di iFixit

Community

130 Membri

13.331 Guide realizzate

Great guide, but how do I move the fingerprint sensor to the new cover?

mela ross - Replica

You need to warm the adhesive so it can be loose

Adwell Cellular -

What adhesive should I use? Thank you!

Calin GV - Replica

Nice guide! Thanks! I got a little question about the coloring of the back panel. What kind of coloring is it? Is it a coating you can take off, or is it more like a layer of paint you can scrape off? I am wondering, because I want to clear the back of my Huawei P10 lite. I hope it’s possible though.

Daan - Replica

Can you send me please back cover.

I'm from Nepal .

Md Usman - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 20

Ultimi 7 Giorni: 104

Ultimi 30 Giorni: 553

Tutti i Tempi: 27,938