Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Release the binding straps by lifting up on the buckle and pulling towards the direction of the end of the ladder.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Move the straps and the highback plate out of the way in order to have clear access to the foot pad screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips screwdriver to remove the panhead, 10mm wide, M4 x 12mm screw located in the middle of the foot pad.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips screwdriver to remove the four ovalhead M6 x 12mm screws that attach the base plate of the binding to the board.
-
Lift or slide the binding off the board and set the screws aside.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the snowboard over so the bottom of the board is facing up.
-
Set the snowboard down on a stable work surface so that it does not rock or move.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
If the bottom of your board has dirt or oil on it, clean it off using a shop towel and a citrus based cleaner.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Hold the iron perpendicular to the snowboard and rub the wax directly onto the iron.
-
Let the wax drip off the iron and onto the snowboard. Cover the entire board evenly with drips.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the iron directly onto the board and smooth down the wax drips.
-
Continue using circular motions until the wax is evenly distributed across the board.
-
Let the wax cool down for a minimum of 30 minutes.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a new razor blade or a commercial wax scraper to remove excess wax from the board. Tilt the razor blade or wax scraper toward the direction of travel at 45°. Pull the wax remover and use long smooth strokes from tip to tail.
-
Continue scraping until all excess wax is removed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Brush the wax using the Scotch Brite Pad to add small grooves. Use long brush strokes starting at the tip of the snowboard and ending at the tail.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
Un commento
Had everything autoriding.com I needed to tune and wax my board myself. No more dropping your board off at the shop and having to go back and get in. Can wax the night before and be on the slopes the following morning. Unless you are doing some serious racing then this kit will have everything you need.