Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Set up the skates on a surface that is okay to get a little messy.
-
The wheels shown in the third photo are very heavily worn. It may be best to simply replace the wheels at this point.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the wheels with the allen wrench. All screws for the pictured boot require a 5/32 allen wrench and are 10mm long.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the wheels are removed from the frame place them on your working surface. The basic idea is to take the most worn wheel and swap it with the least worn wheel, and continue.
-
The pictured swap order (going up/down 2 slots and to the opposite boot) is a common one.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the paper towel to brush off the wheels and frames.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Reinsert the wheel into the frame. Align the wheel with the frame and add the bolt back into the wheel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the boot over, but be careful to hold the bolt into the frame. Add the 10mm screw to the hole and reattach it with the allen wrench.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Do a final check of your skate. This is a very important step, as an improperly aligned screw is easily missed but can fall out very easily.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
3 Commenti
do you fix vive headset
vive headset strap. snap on
I can get one side of the bolts off but not the other side. They just keep spinning when I try to loosen them. Any ideas on how to get the rest of the bolts out?