Aggiusta le tue cose Community Store

How to open a phone with a 3D printer (no joke)

Introduzione

To open a cell phone with a 3D printer sounds bizarre, I know. But as long as you have a reasonably new 3D printer, it's actually very easy.

The requirements are simple: the printer should have a strong, heated print bed. That's all!

Cosa ti serve

  1. How to open a phone with a 3D printer (no joke), How to open a phone with a 3D printer (no joke): passo 1, immagine 1 di 1

    • First, turn on your 3D printer and make sure that there is no residue (such as plastic) left on the print bed.

    • Make sure the printer is fully functional. It must not have any malfunctions, as higher temperatures are used here.

    Traduci

  3. How to open a phone with a 3D printer (no joke): passo 2, immagine 1 di 1

    • Now set the heat of the print bed to 70-80 °C, depending on how capable your printer is. You can safely leave the hotend cool, we don't need it.

    • Do not touch the print bed! You can get burned.

    Traduci

  4. How to open a phone with a 3D printer (no joke): passo 3, immagine 1 di 1

    • Put the cell phone on the print bed.

    • 30 seconds to one minute should be sufficient for most devices. However, if the adhesive is more stubborn, you can safely let it "cook" longer.

    • The print bed transfers a lot of direct heat quickly. That means you don't have to wait long.

    • If you're done with that, you can take the phone off the print bed again and start picking at it.

    • It is best to only handle the phone with protection, such as a kitchen towel or gloves! The underside of the cell phone gets very hot.

    Traduci
Conclusione

You are done, congratulations!

Altre 13 persone hanno completato questa guida.

Un ringraziamento speciale a questi traduttori:

de en

100%

knipwim

oldturkey03

Questi traduttori ci stanno aiutando ad aggiustare il mondo! Vuoi partecipare?
Inizia a tradurre ›

Autore

con 2 altri collaboratori

GamesNic

Membro da: 01/09/20

620 Reputazione

1 Guida realizzata

Distintivi: 7

+4 altri distintivi

6 Commenti

wow, just wow

brilliant

Jeff H - Replica

i was thinking of the same idea, i think you can just use baking paper (Parchment paper) between phone and the build plate, just in case some plastic gets stuck to phone

Tommy - Replica

Dude. This rules. Why oh why did I never think of this 🙄. Heating up my pixel 3 with a hot air station like a fool, when. I have a perfectly good Bambu p1p.

Connor Shattuck - Replica

Lifesaver! Thanks!

Vojtak42 - Replica

If your handy got stuck to the heat bed, then there have been 200 degrees Celsius, just a few degrees too much.

Very nice idea of course.

Ach ja, wenn ich die Backplate lösen möchte, muss auch die Backplate nach unten. Geht das auch mit der Kameraöffnung gut oder gibt es andere Möglichkeiten?

Arrgh R. - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 7

Ultimi 7 Giorni: 32

Ultimi 30 Giorni: 124

Tutti i Tempi: 4,947