Salta al contenuto principale

How to install Window or sliding door pet screen

Cosa ti serve

  1. How to install Window or sliding door pet screen, How to install Window or sliding door pet screen: passo 1, immagine 1 di 1
    • Make sure you start with a frame thats straight and square. I use a table with cleats at 90 degrees to make sure each frame is correct

  2. How to install Window or sliding door pet screen: passo 2, immagine 1 di 1
    • Get the spline started in one corner by forcing it in with a flat blade screwdriver

  3. How to install Window or sliding door pet screen: passo 3, immagine 1 di 1
    • Pre roll the pet screen into the spline groove . Make sure the cloth goes in square and flat. Pull it out and try again if it does not.

  4. How to install Window or sliding door pet screen: passo 4, immagine 1 di 1
    • Use a new sharp blade in your utility knife to cut through pet screen

  5. How to install Window or sliding door pet screen: passo 5, immagine 1 di 1
    • Trim off the excess leaving about 2 inches over the frame before rolling the material in. Leaving too much material hanging will prevent the cloth from laying flat and square.

  6. How to install Window or sliding door pet screen: passo 6, immagine 1 di 1
    • The finished job should look flat and square, the screen bars should not be bowed in.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Adrian Dunevein

Membro da: 06/22/18

133 Reputazione

1 Guida realizzata

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 182