Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disassembling the wireless charging pad, to make it as thin as possible.
-
Inside there is a rubber pad, in order to prevent excessive heat disipating through the back of the charging pad, remove this.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Soldering on thin flexible wires to the + and - on the wireless charging pad
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Start by using the USB board replacement guide, step 1 - 8 in order to gain access to the USB board.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Soldering the wireless charging pad connection + to CN2 on the USB port and - to the ground on the USB port, any part of the external metal surface should work.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a small file to make room for the wires on the back frame just below where the battery sits.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the USB board replacement guide, step 3 - 8 in reverse order to place the back cover, making sure the wires to the charging pad fits through the ready made holes.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Placing the wireless charging pad, slightly off center to keep NFC, which is implemented in the battery, working.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Samsung Galaxy S4 mini booting after fitting wireless charging pad.
-
Annulla: non ho completato questa guida.
Altre 11 persone hanno completato questa guida.
2 Commenti
I tryed to copy your guide and soldered everything in place (5V to this usb pin & Ground to the usb-port), messed up the charging coil a bit by ripping off the whole connector (I now have only 2 pads left for soldering to) and if i place it on the dock, the flashy lights on the dock will turn on, but the phone will not charge.
As you said normal charging by usb works fine, but i cant figure out my problem.
Hi Jann
I have used this approach on three different phones, you need to make sure the + connection on the charging pad is soldered onto the connection on the USB port that is marked by the CN2 arrow on the main board.
I had one that showed the same issues you are describing here, taking the phone apart and resoldering the + connection solved that issue.
Best regards