Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips 1 screwdriver to unfasten the four screws from the back of the case.
-
Remove the battery cover to expose the two remaining screws that hold the case together.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unfasten the last two screws, and open the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Identify the wire(s) which have been disconnected, and identify their original location.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the same Phillips 1 screwdriver, unfasten the two smaller screws holding the controller board to the case .
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Verify that the detached wire(s) reach the intended destination.
-
Use a blade or wire stripper to strip 0.5 cm of insulation off the end of the wire(s) to be soldered.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Re-solder the disconnected wire to the proper joint.
-
Lightly tug on the newly soldered wire to confirm a reliable solder joint.
-