Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Introduzione

Our tents are constructed to stand up to extreme wind and weather conditions. Nevertheless, segments can occasionally break due to excessive strain or other influences (i.e. not completely connecting two segments when setting up the tent, transportation damage). These instructions cover the necessary steps for replacing a tent pole segment.

  1. Loosen the shock cord between the last good segment and the broken segment so that you can remove the pin from the end. Loosen the shock cord between the last good segment and the broken segment so that you can remove the pin from the end.
    • Loosen the shock cord between the last good segment and the broken segment so that you can remove the pin from the end.

    • Attach the shock cord to a clothes pin or similar item.

  2. Pull the pin out of the segment. Pull the pin out of the segment.
    • Pull the pin out of the segment.

  3. Cut off the knot.
    • Cut off the knot.

  4. Remove the shock cord from the broken segment.
    • Remove the shock cord from the broken segment.

    • If the broken segment is in the middle of the tent pole, you have to first remove the good segment(s). Take care to keep the pole segments in the same order when reassembling the tent pole, numbering them if necessary.

  5. To determine which replacement segment to order, measure the outer diameter of the pole and of the tapered end. A caliper makes it easier to measure the diameter. If you don’t have one on hand, you can use a normal measuring tape. A caliper makes it easier to measure the diameter. If you don’t have one on hand, you can use a normal measuring tape.
    • To determine which replacement segment to order, measure the outer diameter of the pole and of the tapered end.

    • A caliper makes it easier to measure the diameter. If you don’t have one on hand, you can use a normal measuring tape.

  6. Transfer the length of the broken segment to the new segment. Start measuring after the tapered end, and mark the length with a marker. Transfer the length of the broken segment to the new segment. Start measuring after the tapered end, and mark the length with a marker.
    • Transfer the length of the broken segment to the new segment. Start measuring after the tapered end, and mark the length with a marker.

  7. Put the pole segment into a vice and saw it off at the correct length.
    • Put the pole segment into a vice and saw it off at the correct length.

  8. File off any sharp ends using the round file on the inside and the flat file for the outer edges. File off any sharp ends using the round file on the inside and the flat file for the outer edges.
    • File off any sharp ends using the round file on the inside and the flat file for the outer edges.

    • Rethread the shock cord through the segment. Tie the end of the shock cord to the pin and thread the other end through the pole.

Linea Traguardo

Un ringraziamento speciale a questi traduttori:

100%

VAUDE Reparaturteam ci sta aiutando ad aggiustare il mondo! Vuoi partecipare?
Inizia a tradurre ›

VAUDE Reparaturteam

Membro da: 22/02/2016

5.517 Reputazione

31 Guide realizzate

Team

Vaudesport Membro di Vaudesport

Community

3 Membri

62 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 20

Tutti i Tempi: 1,489