Salta al contenuto principale

Hover-1 XLS Ignition Replacement

Cosa ti serve

  1. Hover-1 XLS Ignition Replacement, Ignition: passo 1, immagine 1 di 1
    • Remove the six 16mm #3 Hex head screws located on the front panel.

    • The screws are held in with Teflon tape, so use a chemical remover like B'laster to loosen the screws.

  2. Hover-1 XLS Ignition Replacement: passo 2, immagine 1 di 3 Hover-1 XLS Ignition Replacement: passo 2, immagine 2 di 3 Hover-1 XLS Ignition Replacement: passo 2, immagine 3 di 3
    • Grab the front panel and gently lift it up to the side.

    • The front panel is connected to the ignition, so don't pull too hard or the wires will get damaged.

  3. Hover-1 XLS Ignition Replacement: passo 3, immagine 1 di 1
    • Remove the two, 19 mm Phillips #2 screws holding the ignition.

    • Remove the yellow and red wires that are connected to the ignition. To remove them, look at the soldering guide provided by iFixit.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team S1-G2, White Winter 2019 Membro di Cal Poly, Team S1-G2, White Winter 2019

CPSU-WHITE-W19S1G2

3 Membri

6 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 6

Ultimi 30 Giorni: 25

Tutti i Tempi: 1,007