Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
If your hoverboard will not turn on, follow this guide to replace the power button.
Cosa ti serve
-
-
Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.
-
Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
-
Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.
-
-
-
-
Disconnect the battery by holding the yellow connectors and pulling apart.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.