Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the hoverboard so the bottom is facing up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.
-
Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
-
Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grip the bottom right panel and lift to remove it.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the bundle of wires from the clip on the top of the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a Phillips #1 screwdriver, remove the four 14 mm screws that hold the battery on the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery out of the hoverboard by lifting the battery then sliding it out from under the wires.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.