Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
If your Hover-1 Titan battery will no longer hold a charge or your device will not turn on, use this guide to remove and replace your battery.
Cosa ti serve
-
-
Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.
-
Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
-
Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.
-
-
-
-
Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.