Aggiusta la tua roba Comunità Store

Hover-1 Matrix Pad Replacement

Introduzione

The pads on Hover-1 Matrix are weight sensitive, so when they sense weight, the hover board starts to move automatically. Overused pads must be replaced for the Hover-1 Matrix to move when there is a rider.

Cosa ti serve

  1. Hover-1 Matrix Pad Replacement, Pad: passo 1, immagine 1 di 2 Hover-1 Matrix Pad Replacement, Pad: passo 1, immagine 2 di 2

    • Remove the screws on the back of the hoverboard using a Phillips #1 screwdriver.

    • Remove the back shell from the hoverboard.

    Modifica

  2. Hover-1 Matrix Pad Replacement: passo 2, immagine 1 di 1

    • Remove the screws from the metal layer inside the hoverboard using a Phillips #1 screwdriver.

    Modifica

  4. Hover-1 Matrix Pad Replacement: passo 3, immagine 1 di 1

    • Separate the upper shell of the hoverboard and the metal layer inside.

    Modifica

  5. Hover-1 Matrix Pad Replacement: passo 4, immagine 1 di 2 Hover-1 Matrix Pad Replacement: passo 4, immagine 2 di 2

    • Start by identifying the motherboard, which is the green pad shown in the picture.

    • Remove the screws on the corners of the motherboard with the Phillips #1 screwdriver and take it off.

    • There are cables attached to the motherboard so go ahead and unattach them.

    Modifica

  6. Hover-1 Matrix Pad Replacement: passo 5, immagine 1 di 3 Hover-1 Matrix Pad Replacement: passo 5, immagine 2 di 3 Hover-1 Matrix Pad Replacement: passo 5, immagine 3 di 3

    • Use picture 1 as a guide and move the motherboard to the other side.

    • Identify the two black rubber buttons that are shown in the second picture.

    • Remove the two rubber buttons using the Phillips #1 screwdriver.

    Modifica

  7. Hover-1 Matrix Pad Replacement: passo 6, immagine 1 di 1

    • Removing the rubber buttons in the previous step allows you to take the pad off.

    • Finally, take off the old pad and put on a new pad.

    Modifica
Conclusione

To reassemble your device, follow these instructions starting with step number 6 and finishing with step number 1.

Un'altra persona ha completato questa guida.

Autore

con 4 altri collaboratori

Jici Zhuang

Membro da: 10/22/18

362 Reputazione

2 Guide realizzate

Distintivi: 6

+3 altri distintivi

Team

UC Davis, Team S7-G2, Lore Fall 2018 Membro di UC Davis, Team S7-G2, Lore Fall 2018

UCD-LORE-F18S7G2

3 Membri

4 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 12

Tutti i Tempi: 344