Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the six 12mm Phillips #2 screws holding the base plate.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 11mm Phillips #1 screws that hold the base plate to the body.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two connectors on either side of the board by lifting the tab and pulling out.
-
Remove the connector in the middle of the board by squeezing the tab and pulling up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 11mm Phillips #1 screws that hold the cover on.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 11mm Phillips #1 screws that attach the gyroscope board to the mount.
-
Lift the board to reveal the connections on the bottom.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the middle connector by squeezing the top of the tab and pulling up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 12mm Phillips #2 screws that hold the motherboard to the base.
-
Pull the motherboard away from the gyroscope by grabbing it with two hands and pulling it to the right .
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unclip the black connector by squeezing both sides and pulling them apart.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.