Introduzione

This guide is created to replace a damaged or broken back wheel. Tools required are a Hex Bit 4.0 tool, a bit extender, and an allen key.

Parti

Nessuna parte richiesta.

  1. Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.
    • Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.

    • The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.

    • Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

    Aggiungi Commento

  2. Slide off the plastic side panel.
    • Slide off the plastic side panel.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.

    • You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don't spin freely.

    Aggiungi Commento

    • Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

    Aggiungi Commento

    • Slide off the other plastic side panel.

    Aggiungi Commento

    • On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.

    • The axle pops out and the wheel easily comes off.

    • Two washers will pop out with the axle.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Luke Imai

Membro da: 08/10/2018

133 Reputazione

1 Guida realizzata

Team

Cal Poly, Team S15-G5, White Fall 2018 Membro di Cal Poly, Team S15-G5, White Fall 2018

CPSU-WHITE-F18S15G5

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 17

Tutti i Tempi: 33