Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lay the cleaner down horizontally with its wheels closest to the floor.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Hold the lower brush roll with both hands and pull outwards until it is detached.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the 6 marked screws using a Phillips #2 head screwdriver.
-
Remove the brush roller.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a long #2 Philips head screwdriver to remove the 8 numbered screws on the bottom of the cleaner.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the red handle shown to remove the front suction unit from the cleaner.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the Phillips #2 screw at the bottom of the hose.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push down on the handle release button. Pull and disconnect the edge of the top cover on the side of the handle release button.
-
Repeat the above step for the "On/Off" button.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently grab the belt and pry it off from the rollers.
-
Annulla: non ho completato questa guida.
Altre 6 persone hanno completato questa guida.
5 Commenti
Who the heck made this so hard,
Day 5 and 4 people, I still can’t lift the top off to be able to replace belts. Is there a video
Just understand there are more screws to remove then what is described in these 8 steps. Once you removed ALL the screws then the plastic lid comes right off.
How the back do you put the too belts on and seeing how the bag came with two and both were wide what size is the one that goes around the roller the other one control the circle brushes this is one of the most difficult belt change I've bad and I'm counting on car to
There is only 8 screws you need to remove. The diagram makes it hard to know but there are two top ones Directly under the brush ! Once you get them out then comes off no problem at all.