Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Detach the rolling assembly from the body by pushing the button found at the base.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the seven 7.5mm Phillips #1 screws from the brush retainer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the brush and retainer from the rolling assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the eight 4mm Phillips #1 screws from the bottom panel.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 7.5mm Phillips #1 screws from the main body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the black covering from the air tube.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the prongs out through their channels.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the angled neck and feed the prongs out through their channels.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
2 Commenti
How do I get to the receivers for the prongs? They appear to be too loose to make a connection and i have not been able to get into the body to tighten. Is there another way to improve this connection?
Thank you for asking ifixit your 11/1018 question. I’ve been trying to disassemble the body to get at the receiver(s)/socket(s) for those prongs for days. And ifixit, please, have you got a picture of the routing of the brush motor wires from the motor through the rolling assembly, the swiveling universal joint, and along the back of the airtube?