Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 1
    • Before you begin, be sure to unplug the fan.

    • Lay fan on the ground and use your fingers peel the three feet off the bottom of the fan.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 1
    • Remove the three 12mm screws using the Phillips #0 Screwdriver.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 2 : passo 3, immagine 2 di 2
    • Remove the two 10mm screws using the Phillips #0 Screwdriver.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 4, immagine 1 di 1
    • Move the rotation motor left and right to reveal the screw connecting it to the fan.

    • Remove the 18mm screw from the side of the motor using the Phillips #0 Screwdriver.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 5, immagine 1 di 1
    • Using the wire cutters, severe the wires connecting the rotation motor to the fan.

    • To put back together you will need to resolder or use wire connectors to reattach motor.

Linea Traguardo

Team

Cal Poly, Team 10-40, Amido Fall 2014 Membro di Cal Poly, Team 10-40, Amido Fall 2014

CPSU-AMIDO-F14S10G40

3 Membri

7 Guide realizzate

2 Commenti

It seems that these instructions are on “How to eeplacr the oscillation motor". But they neglect the requirement to have a replacement motor or how/where to get the replacement motor. Otherwise the steps seem clear.

Alan A. Kopta - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 10

Tutti i Tempi: 2,648