Pericolo
Potenzialmente Pericoloso
Possibilità di infortunio se questa procedura non viene seguita correttamente. Prestare attenzione e seguire tutte le avvertenze.
Pericolo

Introduzione

This guide will walk you through the steps to remove your rotation motor. Though disassembly is simple, it is a difficult process to put back together because you have to solder wires or use a wire connector to reattach a new rotation motor.

Lay fan on the ground and use your fingers peel the three feet off the bottom of the fan.
  • Lay fan on the ground and use your fingers peel the three feet off the bottom of the fan.

Aggiungi Commento

Remove the three 12mm screws using the Phillips #0 Screwdriver.
  • Remove the three 12mm screws using the Phillips #0 Screwdriver.

Aggiungi Commento

  • Remove the two 10mm screws using the Phillips #0 Screwdriver.

Aggiungi Commento

  • Move the rotation motor left and right to reveal the screw connecting it to the fan.

  • Remove the 18mm screw from the side of the motor using the Phillips #0 Screwdriver.

Aggiungi Commento

  • Using the wire cutters, severe the wires connecting the rotation motor to the fan.

  • To put back together you will need to resolder or use wire connectors to reattach motor.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 10-40, Amido Fall 2014 Membro di Cal Poly, Team 10-40, Amido Fall 2014

CPSU-AMIDO-F14S10G40

3 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 23

Tutti i Tempi: 1,583