Salta al contenuto principale

Introduzione

After extended use, the camera on your device may no longer function properly. Use this guide to replace the front and back camera set of your Hisense Sero 8 device.

Ricambi

Nessuna parte specificata.

  1. Use both the spudger and iFixit opening tool to remove the back cover of the device. Use an opening tool to pry open a corner of the device, then slide the tool down the side of the device to completely open it. Use an opening tool to pry open a corner of the device, then slide the tool down the side of the device to completely open it.
    • Use both the spudger and iFixit opening tool to remove the back cover of the device.

    • Use an opening tool to pry open a corner of the device, then slide the tool down the side of the device to completely open it.

  2. Use your fingers to pull the latch upwards. This action will unlock the ribbon cable.
    • Use your fingers to pull the latch upwards. This action will unlock the ribbon cable.

  3. Use the pointed end of the spudger to lift the camera from the motherboard. Use tweezers to carefully pull out the camera set. Use tweezers to carefully pull out the camera set.
    • Use the pointed end of the spudger to lift the camera from the motherboard.

    • Use tweezers to carefully pull out the camera set.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Katherine

Membro da: 23/02/2015

316 Reputazione

1 Guida realizzata

Team

USF Tampa, Team 1-2, Leahy Winter 2015 Membro di USF Tampa, Team 1-2, Leahy Winter 2015

USFT-LEAHY-W15S1G2

3 Membri

10 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 595