Aggiusta la tua roba Comunità Store

Havoc Heli IR LED Replacement

Introduzione

Before beginning this repair, you should be familiar with soldering a circuit board. The soldering skills needed aren't very in-depth, but you'll be working very close to some other components.

Cosa ti serve

  1. Havoc Heli IR LED Replacement, Havoc Heli IR LED: passo 1, immagine 1 di 2 Havoc Heli IR LED Replacement, Havoc Heli IR LED: passo 1, immagine 2 di 2

    • Power off the controller before disassembly.

    • Place a small piece of tape over the Light button to prevent it from falling out in later steps.

    • Flip the controller over so the back is facing up.

    Modifica

  2. Havoc Heli IR LED Replacement: passo 2, immagine 1 di 3 Havoc Heli IR LED Replacement: passo 2, immagine 2 di 3 Havoc Heli IR LED Replacement: passo 2, immagine 3 di 3

    • Remove the battery compartment screw with a small Phillips screw driver.

    • Lift off the battery cover.

    • Remove the six AA batteries from the compartment.

    Modifica

  4. Havoc Heli IR LED Replacement: passo 3, immagine 1 di 3 Havoc Heli IR LED Replacement: passo 3, immagine 2 di 3 Havoc Heli IR LED Replacement: passo 3, immagine 3 di 3

    • Remove the remaining four screws with a small Phillips screw driver.

    • Flip the device over so the front is facing up.

    • Remove the front cover and place it to the left side.

    • Make sure to note the locations of the joysticks and other controls in case they fall out of place during this or future steps.

    Modifica

  5. Havoc Heli IR LED Replacement: passo 4, immagine 1 di 1

    • Lift up the red IR LED cover to remove it.

    Modifica

  6. Havoc Heli IR LED Replacement: passo 5, immagine 1 di 2 Havoc Heli IR LED Replacement: passo 5, immagine 2 di 2

    • Use the soldering iron and solder wick to remove the solder from the IR LED you're replacing.

    • Pull the LED out through the top.

    Modifica

  7. Havoc Heli IR LED Replacement: passo 6, immagine 1 di 2 Havoc Heli IR LED Replacement: passo 6, immagine 2 di 2

    • Insert the new LED into the slot.

    • Make sure that the short lead of the LED is on the right.

    • Use the soldering iron and solder to connect the new LED.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 2 altri collaboratori

Michael Kent

Membro da: 03/30/16

128 Reputazione

1 Guida realizzata

Distintivi: 4

+ 1 altro distintivo

Team

Michigan Tech, Team 1-13, Lauer Fall 2016 Membro di Michigan Tech, Team 1-13, Lauer Fall 2016

MTU-LAUER-F16S1G13

1 Membro

1 Guida realizzata

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 11

Tutti i Tempi: 526