Hasbro Furby 2012 Switch Replacement

Introduzione

This guide will show you how to replace the switch required for the back panel to be removed. The hardest part of this guide is removing the clips holding the fur on the back panel in place.

Cosa ti serve

Passo 1 Outer Shell

Hasbro Furby 2012 Switch Replacement, Outer Shell: passo 1, immagine 1 di 3

Hasbro Furby 2012 Switch Replacement, Outer Shell: passo 1, immagine 2 di 3

Hasbro Furby 2012 Switch Replacement, Outer Shell: passo 1, immagine 3 di 3

Use a flathead screwdriver to remove the two 10mm screws on the base of the Furby.

Modifica

Passo 2

Hasbro Furby 2012 Switch Replacement: passo 2, immagine 3 di 3

Use a Phillips #0 driver to unscrew the eight 10mm screws.
Remove the base ring after unscrewing all the screws.
Be careful when lifting the base ring from the Furby. There are sharp edges that hold the base ring in place.

Modifica

Passo 3

Unhook the white ribbon from the tab on the base.

Modifica

Passo 4

Hasbro Furby 2012 Switch Replacement: passo 4, immagine 3 di 3

Roll the Furby's fur downward.
Disconnect the now exposed red wire.

Modifica

Passo 5

Hasbro Furby 2012 Switch Replacement: passo 5, immagine 3 di 3

Locate the two middle clips first.
Locate the two remaining clips on Furby's sides, they are opposite each other.
Orient the Furby upside down with the tail facing away from you.

Modifica

Passo 6

Hasbro Furby 2012 Switch Replacement: passo 6, immagine 3 di 3

Insert a metal prying tool directly into the clip opening.
Press upward into the clip. At the same time, use your other hand to pull away the plastic seam from the Furby's body.
Repeat the previous step to remove the remaining three clips.

Modifica

Passo 7

Hasbro Furby 2012 Switch Replacement: passo 7, immagine 3 di 3

Locate the two 10mm screws and remove them with the Phillips #0 head screwdriver.
Lift up on the fur covering until the face of the Furby is exposed.

Modifica

Passo 8

Hasbro Furby 2012 Switch Replacement: passo 8, immagine 3 di 3

Orient the Furby on its side to where the beak is facing left and locate the edge of the aluminum tape.
Lift tape gently and peel back until the tape is nearly removed.
Do not pull on the yellow wire located on the opposite end of the tape.

Modifica

Passo 9

Locate the four 10mm screws. Two on either side of body, and two on top of back plate, around the tape.
Remove the 10mm screws with the Phillips#0 screwdriver.

Modifica

Passo 10

Peel the tape gently, grabbing it from the bottom edge and folding the tape upward.
Peel the tape up until it is nearly detached from the black case.

Modifica

Passo 11

Orient the Furby face down, with the base facing away from you.
Locate the clips below the ears.
Repeat the technique used in Step 6. Create leverage using a metal prying tool to press upward into the clip, while also pulling back on the clip itself.