Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the plastic opening tool, to open the back panel of the device. Start on the longer sides to avoid bending the metal frame at the plug ports.
-
Push down on the plastic opening tool, and push the back panel, repeat this for the 4 sides of the device.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the PH0 screw driver, remove the 7.5 mm screws by turning in a counter-clockwise direction. There are 6 screws on the front panel.
-
Remove all of the 7.5 mm screws, by repeating the same step above. It is not necessary to remove the stand-leg.
-
After unscrewing the 7.5 mm screws, just lift the plastic and you will see the motherboard.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.