Introduzione

Use this guide to separate the back cover from the front.

  1. Remove the outer screen cover by releasing  the top clip from the main body of the device.
    • Remove the outer screen cover by releasing the top clip from the main body of the device.

    Aggiungi Commento

  2. Pull out the stylus from the top right corner of the device.
    • Pull out the stylus from the top right corner of the device.

    Aggiungi Commento

    • Slide the memory cartridge cover up and off the device.

    Aggiungi Commento

    • Remove the battery cover by releasing the clip from the main body of the device.

    Aggiungi Commento

    • Remove the batteries from the device.

    Aggiungi Commento

    • Unscrew the four 2.94mm screws with a #00 Phillips screwdriver.

    • One end of the OEM stylus can unscrew and contains a mini #00 Phillips screwdriver.

    Aggiungi Commento

    • Use the spudger to pry open the casing by applying pressure at 4 clips on both sides of the device.

    • Be careful while opening the casing as there is a flex strip connecting the two halves.

    Aggiungi Commento

    • Disconnect the flex strip from the motherboard with tweezers.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Robert

Membro da: 07/07/2012

23 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 1-2, Regan SU 2012 Membro di Cal Poly, Team 1-2, Regan SU 2012

CPSU-REGAN-SU12S1G2

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 4

Tutti i Tempi: 356