Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Handset Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Cosa ti serve

  1. Handset Replacement, Battery: passo 1, immagine 1 di 2 Handset Replacement, Battery: passo 1, immagine 2 di 2
    • Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone.

  2. Handset Replacement: passo 2, immagine 1 di 1
    • Remove the rechargeable battery pack (BP-T18) by pressing down on the power cable connector and pulling at the same time.

  3. Handset Replacement, Handset: passo 3, immagine 1 di 1
    • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

    • Product is made of brittle plastic.

  4. Handset Replacement: passo 4, immagine 1 di 2 Handset Replacement: passo 4, immagine 2 di 2
    • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

    • The opening should become bigger if you exert force at a 30 degrees angle.

    • Increase the degree of slant until the back cover is completely removed.

  5. Handset Replacement: passo 5, immagine 1 di 2 Handset Replacement: passo 5, immagine 2 di 2
    • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

    • Use a screwdriver to remove all 3 screws.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Caleb Thomas

Membro da: 09/29/16

161 Reputazione

2 Guide realizzate

Team

IUPUI, Team 3-3, Harley Fall 2016 Membro di IUPUI, Team 3-3, Harley Fall 2016

IUPUI-HARLEY-F16S3G3

4 Membri

17 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 50