Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Prerequisite Only

  1. Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone. Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone.
    • Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone.

  2. Remove the rechargeable battery pack (BP-T18) by pressing down on the power cable connector and pulling at the same time.
    • Remove the rechargeable battery pack (BP-T18) by pressing down on the power cable connector and pulling at the same time.

  3. After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.
    • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

    • Product is made of brittle plastic.

  4. Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open. The opening should become bigger if you exert force at a 30 degrees angle.
    • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

    • The opening should become bigger if you exert force at a 30 degrees angle.

    • Increase the degree of slant until the back cover is completely removed.

  5. After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom. Use a screwdriver to remove all 3 screws.
    • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

    • Use a screwdriver to remove all 3 screws.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Caleb Thomas

Membro da: 29/09/2016

161 Reputazione

2 Guide realizzate

Team

IUPUI, Team 3-3, Harley Fall 2016 Membro di IUPUI, Team 3-3, Harley Fall 2016

IUPUI-HARLEY-F16S3G3

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 43